Modified car led rear bumper lights for Toyota Land Cruiser Chinese factory

Installation Steps for modified rear led bumper light Toyota Land Cruiser:

  1. Preparation:
    • Make sure you have the correct LED rear bumper light assemblies designed for your specific Land Cruiser model.
    • Ensure the vehicle’s engine is turned off and the battery is disconnected to prevent electrical accidents.
  2. Access the Rear Bumper:
    • Open the tailgate or trunk to access the rear bumper.
    • Locate and remove the screws, bolts, or fasteners holding the bumper in place. The number and location of these fasteners can vary by Land Cruiser model, so consult your vehicle’s manual.
  3. Remove the Old Lights:
    • Once the bumper is accessible, remove the old rear bumper lights or reflectors by disconnecting the wiring harness and unfastening any mounting screws or clips.
  4. Install the LED Lights:
    • Install the new LED bumper lights in the same location as the old ones. Secure them in place using the provided hardware or mounting points.
    • Connect the wiring harness from the LED lights to the existing wiring. If the LED lights have different connectors, you may need to splice or crimp the wires together. Ensure proper polarity and test the connections.
  5. Secure Wiring and Test Lights:
    • Carefully route and secure the wiring to prevent it from hanging loose or getting damaged. Use zip ties or wiring clips to keep the wires tidy.
    • Reconnect the vehicle’s battery and turn on the lights to test the new LED bumper lights. Ensure that they function correctly, including brake lights and turn signals.
  6. Alignment and Adjustment:
    • After confirming that the LED lights are working correctly, make sure they are properly aligned. Adjust their position if necessary to ensure they are level and facing the right direction.
  7. Reattach the Rear Bumper:
    • Carefully reattach the rear bumper by securing it with the screws, bolts, or fasteners you removed earlier. Tighten them securely.
  8. Final Checks:
    • Double-check the connections, alignment, and functionality of the LED lights.
    • Ensure that the lights comply with local regulations regarding brightness, color, and flashing patterns.